Simplicity Stand for
iCMP Reader Setup

The Simplicity Stand for the iCMP Bluetooth Credit Card Reader keeps your reader secure and accessible in the check-out area. The built-in retraction cable ensures the iCMP never walks off or gets misplaced.

Watch our setup video below:

Simplicity Stand for iCMP Setup

Table of Contents

In the Box

The Simplicity Stand for the iCMP Bluetooth Credit Card Reader ships with the parts listed below.

Click to Enlarge
  • Simplicity Stand for iCMP Reader
  • Stand insert
  • Adhesive squares
  • 4 non-sliding feet
  • Apple Pay acceptance decal
  • *Shown separately above, the stand and stand insert come connected by a retraction cable.

    Stand Setup

    The Simplicity Stand arrives almost out-of-the-box ready. There are just a few setup steps to complete.

    1. Remove the backing from the insert to expose the adhesive.
    2. Place the iCMP on the adhesive and hold firmly in place for 5 minutes.
    3. Wait overnight for the adhesive to cure.
      Failure to complete this step may cause the reader to separate from the stand when in use.
    4. Decide how to display the iCMP stand:
      • For permanent placement, use 4 #10 screws (not included) to secure the stand to a countertop.
      • For temporary placement, apply the non-sliding feet to the bottom corners of the stand.

    Setup is complete. The built-in retraction cable keeps the reader tethered to the stand.

    Having problems with the stand’s adhesive or retraction cable? Visit our Simplicity Stand for iCMP Troubleshooting guide for help.